Menu pages - General
A: R104GB01A.PMD
B: R104DE01A.PMD
E: 290304 / TCS
G: 140404 / T. Wenger
Section 1
Page 9
Select individual data sets
User data
The User data comprise all data relating to the
User program.
These include:
- Main program
- Subprogram
- CNC program
- Parallel program
- Palletising program
- Lock area 1-5
These data sets can be saved/loaded under one
name at the same time.
It is also possible to save and reload each of
these data sets individually.
To do this simply select the touch key
(for individual data sets) after
having selected the User data.
You can then use the two selection boxes to
select the corresponding individual data set.
Note
The system always saves the data set and
the selected data set type in the ”Data Set”
box.
Each of these individual data sets has a
separate extension.
Data record type Extension
General data record *.r41
Main program *.r4m
Subprogram *.r4s
Parallel program *.r4p
CNC-program *.r4c
Palletising program *.r4z
Lock area *:r4l
R10B4GB_050
User data
To Next Page
Loading...
