Status pages
A: R104GB02A.PMD
B: R104DE02A.PMD
E: 290304 / TCS
G: 140404 / T. Wenger
Section 2
Page 17
All the digital outputs belonging to the periphery
interface are shown here.
digital output set to logic ”0”
digital output set to logic ”1”
Each periphery is matched to an individual
application. The user can therefore rename
each of the digital inputs and outputs according
to their specific function.
Simply press the Service key to switch to
the periphery interface configuration page. Refer
to the Service pages section.
Note
User level 30 or higher is required here.
To Next Page
Loading...
