Baumuller BUS 6 VC - Page 65

Parameter
V-Controller (BUS 6 VC) 63
Baumüller Nürnberg Electronic GmbH & Co. KG 5.03047.01
P195 DSM message Pxxx
If a message has occurred (P192 ≠ 0), this parameter shows the parameter no. involved.
P193 DSM DS name
A maximum of 4 data sets can be managed in each memory area. They are selected via the
parameter „data set name“.
P194 DSM DS article no.
Article no. of a data set ex factory.
P197 DSM DS program cycles
Number of write actions on this data set.
P196 DSM load data set
The data set with the corresponding number (0...2) can be loaded from the EEPROM into the
working memory via this parameter.
The following procedure should be adhered to:
! Firstly, ensure that the status of the data set management (P191) is either set to 0
(STOP) or to 0003 (STAND_BY).
! Next enter the number of the required data set in the parameter, P196 (DSM load data
set).
! All further steps follow independently:
– The number of the required data set is displayed in parameter P193.
– The command 6 „load data set from EEPROM into user memory“ is visible in the pa-
rameter P191 (DSM command).
– The data set is loaded.
! The procedure is completed once the DSM status displays again state 0003
(STAND_BY).
(Incidentally entered numbers should be ignored.)
Value Memory range EEPROM (non-volatile)
0 data set 0 (boot data set)
1 data set 1
2 data set 2
3 data set 3 (write-protected data set)