7219623.01 (1-04/15) 30
INSTALLER Section (en)
INSTRUCTIONS PRIOR TO INSTALLATION
lighting and using the boiler are contained in the ‘Instructions for Users’ section. Installation, servicing and running of domestic
This boiler can be connected to any type of double- or single-pipe convector plate, radiator or thermoconvector. Design the
danger.
Initial lighting of the boiler must be carried out by an authorised Service Engineer, as indicated on the attached sheet.
ADDITIONAL PUMP WARNING
SOLAR WARNING
entering the boiler must not exceed 60°C.
Do not leave any packaging (plastic bags, polystyrene, etc.) within the reach of children as they are a potential source of danger.
9. INSTALLING THE BOILER
The template outline is shown in annex "SECTION" C at the end of this manual.
Avoid horizontal stretches.
Do not lift the boiler exerting pressure on the plastic parts like the siphon and the ue turret.
Tighten the boiler water connections with care (maximum tightening torque 30 Nm).
9.1 CONTENTS OF PACK
Boiler support bar
Gas tap (1) and Water inlet tap (2)
ACCESSORIES
9.2 BOILER DIMENSIONS AND GAS WATER CONNECTIONS
"SECTION"
C at the end of the manual.
A Condensate drain point D GAS inlet
B E
C F Heating return
1
2
To Next Page
Loading...
