BBV TX1500 system - VISTA COAX EXTENDED COMMANDS; RS422 (SIMPLEX) TELEMETRY WIRING

TX1500 Manual V3.5 Dec 07 Page 21 of 40 MATRIX PROGRAMMING/USER GUIDE
VISTA Coax Extended Commands on the Tx1500Matrix
Supports 86 Presets Presets 1 thought to 88 except 33 & 34
Keyboard VISTA COAX Command Keyboard VISTA COAX Command
91 Preset RUN Learn 1 1 Patrol RUN Tour 1
92 Preset RUN Learn 2 2 Patrol RUN Tour 2
93 Preset Program Learn 1 Iris Open Enter
94 Preset Program Learn 2 Iris Close ESC
1# Enter Dome Menu (min idome) VPD-4WP-P-C/L
1# 1# Enter Dome Menu (VISTA POWER DOME)
DomeMENUPassword“1234”
On the VPD-4WP-P-C/L if you press the Autopan Key nothing will happen until you either:
i) Press the Iris close and it will start a dome scan if saved.
ii) Use the joystick and it will go in to the menu Password screen.
RS422 (simplex) TELEMETRY OUT
1 = DO NOT USE
2 = DO NOT USE
3 = DO NOT USE
4 = TxA to Dome RA(+)
TxB to Dome RB(-) = 5
DO NOT USE = 6
DO NOT USE = 7
SCREEN = 8
RJ45 breakout box
G
N
D
R
A
R
B
Dome 1
G
N
D
R
A
R
B
Dome 2
G
N
D
R
A
R
B
Dome 3
This port provides telemetry control via BBV RS422 (simplex). A Cat 5 RJ45 patch cable and breakout box is used to
connect the VISTA DOME CAMERAS via single twisted pair cable. It is possible to either wire the network in a daisy
chained or star configuration using an optional RS422 Starcard.
1 = DO NOT USE
2 = DO NOT USE
3 = DO NOT USE
4 = TxA to Dome RA(+)TxB to Dome RB(-) = 5
DO NOT USE = 6
SCREEN = 7
SCREEN = 8