64
3.13 BIOS Setting Password
When you select this function, a message as below will appear on the screen:
Type the password, up to six characters in length, and press <Enter>. The password typed now will replace
any previously set password from CMOS memory. You will be prompted to confirm the password. Retype
the password the press <Enter>. You may also press <ESC> to abort the selection and not enter a
password.
To clear a set password, just press <Enter> when you are prompted to enter the password. A message will
show up confirming the password will be disabled. Once the password is disabled, the system will boot and
you can enter Setup without entering any password.
When a password has been set, you will be prompted to enter it every time you try to enter Setup. This
prevents an unauthorized person from changing any part of your system configuration.
To Previous Page
Loading...
