EasyManuals Logo

BEARING CHECKER SPM User Manual

BEARING CHECKER SPM
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
7
A
Main display
B
A
Main display
B
Unit for bearing diameter
Bearing diameter can be displayed in either mm or inch.
To select your unit of measurement:
1. Go to the Main display (A).
2. Use the arrow keys to navigate to the General Set-
tings icon (B), then press ENTER.
3. In the General Settings menu, select the Units icon
(C) and press ENTER.
4. In the Units display (D), use the UP/DOWN keys to
select millimeters or inch as the unit of measurement.
5. Press the ENTER key to save your setting.
To return to the Main display, press the BACK key.
Settings
C
General settings
D
Units
Display contrast and screensaver
timeout
To set the display contrast and the amount of idle time
that should elapse before the screensaver is activated:
1. Go to the Main display (A).
2. Use the arrow keys to navigate to the General Set-
tings icon (B), then press ENTER.
3. In the General Settings menu, select the Display
contrast icon (C) and press ENTER to open the display
contrast and screensaver settings (D).
4. Use the UP/DOWN arrow keys to set the time to wait
(5 - 600 seconds) before the screensaver dims the
display backlight.
5. Use the LEFT/RIGHT arrow keys to set the display
contrast.
6. Press the ENTER key to save your settings and return
to the General settings menu.
To return to the Main display, press the BACK key.
General settings
Display
contrast
C
D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BEARING CHECKER SPM and is the answer not in the manual?

BEARING CHECKER SPM Specifications

General IconGeneral
BrandBEARING CHECKER
ModelSPM
CategoryMeasuring Instruments
LanguageEnglish