30 Screen page "Terminal"
Communication with the servo amplifier is made through ASCII commands. You can obtain a complete list of
the commands from our application department.
Commands that are sent to the servo amplifier are marked by "-->", the answers from the servo amplifier appear
without any preceding characters.
When using this integrated terminal function, the following restrictions apply:
l
The last 200 lines are displayed
l
The transmission from the servo amplifier to the PC is limited to a maximum of 1000 bytes per com
-
mand
l
A watchdog timer limits the transmission time in both directions to a maximum of 3 sec.
If the number of characters is more than 1000, or the transmission time is more than 3 seconds, then the
terminal reports a fault.
Command
Enter the ASCII command here, with the parameters. End the entry with RETURN or operate the APPLY button
to start the transmission.
Theterminalsoftwareshouldbeusedonlybyexperts.
In many instances there will be no co nfirmation query.
86 Setup Software
Screen page "Terminal" 07/03 BECKHOFF
To Next Page
Loading...