114 DeepMind 12 User Manual
ModDlyRev (MODULATION/DELAY/REVERB)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1 TIM Time ms 1.0 ms 1500.0 ms Sets the master delay time. Time synchronised options from 4 to 1/64 bars.
2 FAC Factor — — — Sets the delay to rhythmic fractions (1, ½ ⁄ ⁄).
3* FBK Feedback % 0.0% 100% Controls the percentage of positive feedback.
4* FHC FeedHC Hz 200.0 Hz 20000.0 Hz Adjusts the high cut lter frequency in the feedback path.
5* DEP Depth % 0.0% 100% Controls the depth (amount) of modulation.
6* SPD Speed Hz 0.0 Hz 10.0 Hz Adjusts the rate of the modulation. Time synchronised options from 4 to 1/64 bars.
7 MOD Mode — PAR SER Controls the processor chain routing (Serial/Parallel)
8 RTY Rtype — — — Reverb Type can be set to AMB (Ambience), CLUB, or HALL.
9* DCY Decay — 1.0 10.0 Controls the amount of time it takes for the reverb to dissipate.
10* DMP Damping — 1000 Hz 20000 Hz Determines the decay of high frequencies within the reverb tail.
11* BAL Balance — -100.0 100.0 Adjusts ratio of the delay signal to the reverb signal.
12* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals
* These parameters are available as modulation destinations in the Modulation Matrix
Chorus (STEREO CHORUS)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1* SPD Speed Hz 0.0 Hz 5Hz Sets the modulation speed. Time synchronised options from 4 to 1/64 bars.
2* WDL WidthL % 0.0% 100% Determines the amount of modulated delay in the left channel.
3* WDR WidthR % 0.0% 100% Determines the amount of modulated delay in the right channel.
4 DLL DelayL ms 0.5 ms 50.0 ms Sets the total amount of delay for the left channel.
5 DLR DelayR ms 0.5 ms 50.0 ms Sets the total amount of delay for the right channel.
6* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals.
7* LC LoCut Hz 10.0 Hz 500.0 Hz Allows the low frequencies in the signal to be reduced.
8* HC Hi Cut Hz 200.0 Hz 20000.0 Hz Allows the high frequencies in the signal to be reduced.
9 PHS Phase — 0.0 100.0 Adjusts the phase oset of the LFO between left and right channel.
10 WAV Wave % 0.0% 100% Blends between the digital triangular chorus sound and the classic analog sine wave.
11* SPR Spread % 0.0% 100% Adjusts how much of the left channel is mixed into the right and vice versa.
* These parameters are available as modulation destinations in the Modulation Matrix
To Next Page
Loading...
Need help?
General
