116 DeepMind 12 User Manual
Phaser (STEREO PHASER)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1* SPD Speed Hz 0.0 Hz 5 Hz Sets the modulation speed. Time synchronised options from 4 to 1/64 bars.
2* DEP Depth % 0.0% 100% Controls the depth (amount) of modulation.
3* RES Reso % 0.0% 100% Adjusts the resonance of the multiple lter stages.
4* BAS Base Freq Hz 20 Hz 15000 Hz Adjusts the frequency range of the modulated lters.
5 STG Stages — 2.0 12.0 Controls how many lter stages are used.
6* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals.
7 WAV Wave — -50.0 +50.0 Shapes the symmetry of the LFO waveform.
8 PHS Phase deg 0.0 180.0 Adjusts the LFO phase dierence between the left and right channel
9* ENV EnvMod ms -100.0% 100% Adjusts the level of positive or negative envelope modulation.
10* ATK Attack ms 10.0 ms 1000.0 ms Controls the envelope attack stage time.
11* HLD Hold ms 1.0 ms 2000.0 ms Controls the envelope hold stage time.
12* REL Release ms 10.0 ms 1000.0 ms Controls the envelope release stage time.
* These parameters are available as modulation destinations in the Modulation Matrix
MoodFilter (MOOG TYPE FILTER)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1 SPD Speed Hz 0.0 Hz 20.0 Hz Sets the modulation speed. Time synchronised options from 4 to 1/64 bars.
2* DEP Depth % 0.0% 100% Controls the depth (amount) of modulation.
3* RES Resonance % 0.0% 100% Adjusts the resonance of the lter.
4* FRQ Base Freq Hz 20 Hz 15000 Hz Adjusts the level of positive or negative envelope modulation.
5 TYP Type LP — — — Selects between low pass (LP), high-pass (HP), band-pass (BP) and Notch (NOT).
6* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals.
7 WAV Wave — — — Selects modulation waveform Triangular, Sine, Saw Up, Saw Down, Ramp, Square or Random.
8* ENV EnvMod % -100.0% 100% Adjusts the level of positive or negative envelope modulation.
9* ATK Attack ms 10.0 ms 249.9 ms Controls the lter attack time.
10* REL Release ms 10.0 ms 500.0 ms Controls the lter release time.
11* DRV Drive % 0.0% 100% Adjusts the level, also introduces an overdrive eect if pushed hard.
12 4P 4-Pole — 2P 4P 100.0 Adjusts the slope of the lter from 2-pole to 4-pole (steeper).
* These parameters are available as modulation destinations in the Modulation Matrix