38 DeepMind 12 User Manual
Page 1 shows the ARP/SEQ and LFO faders. (The Portamento rotary knob is
represented by the rst fader on the left.)
Page 2 shows the OSC faders:
Page 3 shows the UNISON, VCF, HPF and VCA faders:
Page 4 shows the ENVELOPE faders:
Note: You can still select specic envelopes to match the faders, depending
on your requirements.
6. Press COMPARE again to exit the COMPARE menus at any time and return to
the PROG menu.
7.5 WRITE (Write Menu)
1. To write a program to memory, rst press the WRITE switch.
2. The WRITE PROGRAM menu will then appear:
3. In this menu you can use the -/NO or +/YES switches to navigate through the
sections. The selected section will be highlighted by an inverted character
(white on black).
4. The rst section is the program location where the current program will be
saved. You can use the BANK/UP, BANK/DOWN switches, the rotary knob,
or the DATA ENTRY fader to select the required BANK (A-H) and PROGRAM
NUMBER (1-128). Be careful that you do not overwrite an existing program
you would rather keep.
5. The second section is the "CATEGORY" where you can select any of the
available program categories. Again you can use the BANK/UP, BANK/DOWN
switches, the rotary knob, or the fader to select the required category.
6. The third section is "TO BE REPLACED BY" which shows the name of the
program to be written. If you want to change the name, you can use the
-/NO or +/YES switches to step through each character of the name and
use the BANK/UP, BANK/DOWN switches, the rotary knob, or the faders to
change the character.
7. There are also two short-cuts for selecting characters, indicated by text in
bottom of the display, just above the FX and GLOBAL switches.
Note: These two short-cuts will only appear when you are editing the name
of the TO BE REPLACED BY program.
a-A-0 - Press the FX switch to cycle between lower-case, upper-case, and
numbers/special characters.
DEL - Press the GLOBAL switch to delete the currently selected character.
To Next Page
Loading...
Need help?
General
