72 DeepMind 12 User Manual
• P.MOD MODE - This option allows you to select which oscillators are
controlled by the OSC 1 PITCH MOD fader.
Note: It is useful to have both OSCs responding for eects like tremolo.
• OSC1+2 -Both OSCs have PITCH MODULATION applied to them.
• OSC1 - Only OSC 1 has PITCH MODULATION applied to it.
• KEY-DN-RESET - This option allows you to reset the phase of the oscillator
waveform to start from its reset point each time a key is pressed.
The default setting for KEY-DN-RESET is O.
5. To exit the OSC 1 PARAMETERS menu, press the PROG switch to return the
main display, or press the OSC EDIT switch again to continue to the OSC 2
PARAMETERS menu.
OSC 1 (SAW)
KEY-DN-RESET
OFF
KEY-DN-RESET
ON
OSC 1 KEY DOWN RESET
KEY PRESS KEY PRESS KEY PRESS
8.3.12 OSC EDIT SWITCH (OSC 2)
1. To access the OSC EDIT menu, press the OSC EDIT switch.
2. The OSC EDIT switch will then start ashing and the OSC 1 PARAMETERS
menu is then shown.
3. Press the EDIT switch again to show the OSC 2 PARAMETERS menu:
4. To navigate the options in the OSC 2 PARAMETERS menu, use the BANK/UP or
BANK/DOWN switches.
5. Selected parameters are adjusted using the -/NO or +/YES switches, the
rotary knob or the DATA ENTRY fader. The rotary knob has a click which
allows very accurate control. The fader allows rapid adjustment across the
full range.
The following options are available in the OSC 2 EDIT menu:
• RANGE - This option allows you selects the base pitch of OSC2 as follows:
• 16' - The lowest note on the keyboard (C) is tuned to 16.35 Hz.
• 8' - The lowest note on the keyboard (C) is tuned to 32.7 Hz.
• 4'- The lowest note on the keyboard (C) is tuned to 65.4 Hz.
The default setting for the RANGE is 8'.
• P. M O D -SRC - This option allows you to select the source for the amount of
PITCH MODULATION from the following:
• LFO-1 - Bipolar use of the LFO 1 waveform.
• LFO-2 - Bipolar use of the LFO 2 waveform.
FLASHING=EDIT
OSC 2 PITCH MODULATION AMOUNT (LFO AS SOURCE)
OSC 2
LFO (SIN)
PITCH MOD LOW
PITCH MOD MED
PITCH MOD HIGH