BEIER-Electronic SFR-1 - Engine Sound

GB Sound speed controller SFR-1
20 BEIER-Electronic 06.02.2019
Engine sound
The engine sound consists of several single<A[single|individual]> noises. Normally
there is an engine start noise, an idling noise, a driving noise and an engine stop
noise. This module also offers the possibility to imitate up to five different driving
sounds (for example for gears), up to eight change sounds between the driving
sounds (for example when you change the gears), a reverse engine sound, a break
noise and cornering squeak.
All engine sounds (therefore also the reverse driving- and brake noise) are played
only when the engine sound is switched on (see page 22).
Start engine noise (cold –and warmstart)
The start engine noise is played when the engine sound is switched on. After the
starting noise is played, the sound changes into the idle sound.
If the engine sound is switched on and the vehicle is already in motion, the starting
noise will skip and the module directly plays the engine noise.
As an option, two different engine start noises can be used. The engine coldstart
sound (e.g. the starting takes longer, until the engine runs smoothly) and the engine
start sound for a warmstart (engine starts immediately). Which starting sound is
played, depends on how long the engine was running before. This time can be
configured in the Sound-Teacher. (Configuration  Engine sound  Time for
warmstart).
If you don’t need two different engine start sounds, you can use one of the two slots
for your engine start sound. The sound module always plays the sound slot, which is
filled with a sound.
Idle sound
The idle sound is always played when the vehicle is in idle. The sound is played in
an endless loop. Therefore just a short sound (approx. 1-5s) is required for this
sound slot. In general the longer the sounds file, the better the quality of the idle
noise.
Vehicle start sound
The starting sound is played uniquely when the vehicle sets off (idle  drive).
Vehicle stop sound
The stopping noise is played once as soon as the vehicle stops (drive  idle).
Engine stop sound
The engine stopping noise is played when the engine sound is switched off.