GB Sound speed controller SFR-1
06.02.2019 BEIER-Electronic 85
Saving sounds and configurations on SD card
Please only use the SFR-1 Sound-Teacher to program the SD card and do not copy
any files to SD card “by hand“. Please do not delete any files on the SD card.
The sound module must be disconnected from the supply voltage before inserting or
pulling out the SD card!
1. Pull out the SD card from the slot of the SFR-1. The card should be handled
with care in order to prevent damage because the side with the golden
contacts is very sensitive to scratches.
2. Insert the SD card in the card reader, which is connected to the PC.
3. Now start the SFR-1 Sound-Teacher and choose the desired project, the new
sounds or setup the configuration.
4. Choose (if necessary) the drive letter of your SD card in the menue “SD card”.
If you have connected additional removable devices (such as SD cards or
USB sticks) to your computer, please pay attention to choose the right device.
5. The Button „Save project data onto SD card“ is used to write all sounds and
configurations onto SD card. This can take up to serveral minutes. The speed
depends on the amount of data.
6. Now you can remove the SD card from the card reader and insert it carefully
into the slot of the SFR-1. The golden contacts must face downwards.
To Next Page
Loading...
