GB Sound speed controller SFR-1
06.02.2019 BEIER-Electronic 51
Configuring sounds
A lot of different sounds can be saved in the sound slots of the SFR-1. The sounds
are divided into five different ranges:
• Engine sound
• Engine sound 2
• Additional sounds
• Random sounds
• WAV-Player
Click with the mouse on the corresponding tab to configure a sound.
Indicates the folder where the sound project is to be saved.
Indicates the name of this slot, i.e. what sort of sound can
be saved here (e.g. engine start sound).
File name of the WAV file which is saved in this slot.
This button is used to load a new sound file into the slot.
Erases the file from the slot.
Plays back the file via the PC’s integral loudspeaker.
At this point you can select the different play-back modes
Determines which outputs or output sequences are used
when particular sounds are played back.
The volume of every sound can be changed here.
Shows length of the sound.
Opening of sound files
The folder „Sounds“ on the DVD contains general examples of soundfiles.
The folder „SFR-1 Sounds“ contains drive sounds for a lot of different vehicles.
With a click on the button, the Windows “file open dialog” opens, in which you
can select the wanted sound file on your hard disk.
All WAV-files with following properties can be opened:
• 22,050 kHz or 44,100 kHz
• 8 Bit or 16 Bit
• Mono or Stereo
To Next Page
