BEIER-Electronic SFR-1 - Page 66

GB Sound speed controller SFR-1
66 BEIER-Electronic 06.02.2019
Configuration - EKMFA
If you want to use EMKFA mode, you have to activate it first.
The used functions for EKMFA mode (see page Fehler! Textmarke nicht definiert.)
can be configured here.
Of course, you don’t have to assign every position (2 x 15 positions).
Activation delay
Certain times can be set that determine how long the joystick or switch must be in
the positions A/D and B/C in order to activate the corresponding functions. Times
between 10 and 2500ms are possible.
However, the values set here are always valid for all proportional channels. It is not
possible to define delays for one channel separately.
The reset button will restore the standard values.