2-16
11 Before zipper (zipper clamp) clamp lateral (option)
16 Time before insertion
after the set time the main clamp drives from the insertion position to
sewing start (foot pedal machine process pressed)
17 Piping blowing off
piping and flap are blown to the folder, to prevent a tilt movement of
the piping; time may not be too long, since otherwise the thread will be
blown to the needle
18 ‘Thread clamp open’ at seam start (Beisler sewing head)
after the first two stitches the upper threads should be released from
the thread clamp; after the time defined here, the thread clamp opens
19 ‘Thread clamp open’ - duration
duration of ‘thread clamp open’ at seam start
20 Point stitches during sewing
allows one or several stitches at seam start and end to meet the end
point exactly
21 Cut til upper thread
time for catching and cutting of the upper thread
22 Upper thread cutting time
length of the threads after upper threads picked up
23 Scissor cutting time
influences the zipper scissor to cut the zipper completely before
moving to the end position
24 Drive to cutting
percentage of the clamp speed used by the main clamp to drive to the
mitre knifes
25 Mitre knife distance
distance between the mitre knifes
26 Mitre knifes cutting time
cutting time of the mitre knifes
27 Main clamp open
open the main clamp after mitre cutting; if time’s too short, the work
piece may slip out of the machine before taken by the stacker
28 Taking parts
when taking parts with weak clamp (inner pocket production) the main
clamp opens after mitre cutting, the final roller moves the part lateral
from the clamp; then the clamp is switched with this parameter, that
the main clamp detects the work piece faster and brings it to the
insertion position
29 Turn til final roller [0.1 sec.]
time for the start of the final roller
30 Time til final roller up [0.5 sec.]
keeping the work piece after rolling, until the stacker has taken the
work piece
31 Clamp speed [90%]
speed of the main clamp to the insertion position
32 Process step-by-step [00]
enter >01 to enable the switching of all machine functions
33 Remaining thread counter on/off [00] (option)
function can be enabled and disabled; 01 = remaining thread
monitoring on; this disables the spool thread counter
34 Thread cutter revs [250 Rpm]
positioning revs for threat cutting systems:
Beisler sewing head 250 Rpm
Pfaff sewing head 180 Rpm
Singer sewing head 250 Rpm
To Next Page
Loading...
