Beisler 100 - Cut off Power Supply; Preparing Measures; Release Pneumatic Pressure

3-4
0.4 Preparing measures
In this manual, you will find hints at any measure, where the machine must
be powered off or the pneumatic pressure must be released:
<power off> machine must be cut off the power supply
<release pressure> pneumatic pressure must be released from the
machine
To be able to work under maximized safety, the preparing measures should
be obeyed at any time.
0.4.1 Cut off power supply
Use the mains/emergency stop switch to switch off the machine. Cut off the
power supply and assure that it can’t be restored unintentedly.
0.4.2 Release pneumatic pressure
Close the air supply with the black switch at the air supply unit. Cut the
machine from the air supply and assure, that it can’t be restored unintentedly.