2-29
5.5.3.1 Machine Code
This is required to copy seam parameters, basic parameters or seam
programs and to select a part of the diagnostic programs.
The code number is ‘50190’. If this code is disabled due to safety reasons,
‘00000’ must be entered.
5.5.3.2 Safety Code
This code is required for the execution of most of the diagnostic functions. It
can be ordered in written form giving the machine number from the service
department of the company Beisler.
5.6 Preset sewing programs
The following shows the factory-set structure of the seams in the memory
buffer:
Seam-No. Seam
01 ... 09 Jacket outside pocket; with/without flap
10 ... 19 Jacket outside pocket; slanted pocket / slanted flap
20 ... 29 Inside pocket; lining pocket with pelon
30 ... 39 Pants pocket; pants front/back pocket with/without flap
40 ... 49 Pockets with zipper
The following shows the factory-set occupation of several memory locations
with seams:
Memory loc. Seam
M01 01 Flap pocket; jacket right panel
02 Flap pocket; jacket left panel
03 Welt pocket; jacket right panel
04 Welt pocket; jacket left panel
M02 10 Slanted pocket with flap; right panel
11 Slanted pocket with flap; left panel
12 Slanted welt pocket; right panel
13 Slanted welt pocket; left panel
M03 20 Jacket inside pocket with pelon; pocket length 100 mm
21 Jacket inside pocket with pelon; pocket length 100 mm
22 Jacket inside pocket with pelon; pocket length 150 mm
23 Jacket inside pocket with pelon; pocket length 150 mm
M04 30 Pants back pocket
31 Pants front pocket
32 Pants back pocket with flap
33 Pants back pocket with button loop
M05 40 Pocket with zipper
41 Pants back pocket with zipper
M07 16 Jacket breast welt pocket
To Next Page
Loading...
