© BEKA 201 All rights reserved!6
...a product of BEKA
3.3 Hazards in case of non-observance of the safety instructions
Results of the can be , environment and for thenon-observance safety instructions hazards to persons
central lubrication pump itself. Non-observance of the safety instructions may result in the loss of any liability
claims. In detail the non-observance could entail the following hazards:
· Failure of important .device functions
· Failure of prescribed methods for maintenance and repair.
· Danger to persons by electrical, mechanical and chemical effects.
· Danger to the environment by leakage of hazardous substances.
3.4 Operators´obligations
· If movable, rotating, hot or could parts of the device bear risks, these need to be secured against contact
by the customer.This protection against contact must not be removed.
· Any leakages of hazardous substances to be conveyed must be drained in a way that no risk for persons
or the environment arise.
· Keep to all legal provisions.
· Hazards due to electricity are to be excluded.
· Examination of pipes and hoses regarding safe provision, use, proper assembly and function has to be
carried out according to regionally applicable directives. Inspection may not be exceeded.intervals
· Defective pipes or houses must be replaced immediately and appropriately.
· Hydraulic hoses and polyamide pipes are subject to a natural aging-process and thus have to be
exchanged in regular intervals according to the manufacturer´s specifications.
· Asafety data sheet of the currently used lubricant needs to be provided at the device.
3.5 Safety instructions for maintenance, inspection and assembly
All and may only be carried out by who ismaintenance, inspection assembly works qualified personnel
sufficiently informed by thorough reading of the user information.
Generally all works complete standstil pressurelessat the device may only be carried out during l and in
as well as . Furthermore appropriate (gogglesdisconnected condition personal protection equipment
among others) is necessary. The shutdown procedure of the central lubrication pump as described in the
manual must be strictly followed.
Secure the central lubrication pump against intentional or unintentional duringrecommissioning
maintenance works or repair. All safety and protection arrangements have to be put back in place again
immediately after finishing the works.
Environmental hazardous media must be disposed professionally and in correspondence to relevant legal
provisions. and have to be cleaned before maintenance works. PleasePolluted contaminated surfaces
wear protection equipment to that purpose. See the lubricant manufactures´safety data sheets hereto,
respectively the data sheet provided by the manufacturers of auxiliaries and working materials.
8
To Next Page
Loading...
Need help?
General
