© BEKA 201 All rights reserved!6
...a product of BEKA
3. General safety instructions
All persons that are in charge with the assembly, start-up, maintenance and operation of the central lubrication pump
GIGA/ GIGAPLUS must carefully read these instructions. Furthermore this manual always has to be available on site!
Basic notes for the setup, operation and maintenance can be found below!
3.1 Safety instructions:
Do not only observe the safety instructions within this point but also have a look at the special safety warnings that are
implemented in other parts of this documentation.
Warning of electrical voltage.
Safety instructions which in case of non-observance might cause hazards to persons are marked with the
general danger symbol.
This symbol warns of hot surfaces
Warning of suspended loads.
Warning of material damage due to electrostatic discharge! Marks potential risks which may result in material
damage, if not avoided.
This heading is used if the improper or general non-observeance of the operating manual,
specified work flow and the like result in device damage.
This term is used to indicate specialities.
Instructions which are directly attached to the have to be strictlycentral lubrication pump GIGA / GIGA PLUS
observed and kept in readable condition!
3.2 Qualification and training of staff
The staff in charge for operation, maintenance, inspection and assembly has to have the according
qualification for these . Competence, and musttasks responsibility supervision of staff be clearly defined by
the operator. In case the staff does not have the necessary knowledge it has to be instructed and trained
accordingly. The operator is obliged that the staff fully understands the content of this user information.
Note!
Attention!
7
To Next Page
Loading...
Need help?
General
