© BEKA 201 All rights reserved!6
...a product of BEKA
7.10 Integrated pressure switch
The is necessary in . This can be installed into the pump orpressure switch single line systems either external
directly integrated in the pump.
Function:
If the in the main line of the pump is the pressure switch sends a to thechangeover pressure reached, signal signal
transmitter magnetic valve, e.g. PLC. This device switches over the and the main line is relieved ( ig. 1 ).F8
In order to send a of the pressure switch to an , the motor covering has asignal external signal transmitter 4-pole plug
type connection blue nutat the side with a . Here cables with different lengths can be connected (see 15 spare part list
and 16 spare part drawing).
Fig. 19:
8. Assembly instructions
8.1 Assembly of the central lubrication pumps GIGAand GIGA PLUS
Check the central lubrication pump for possible transport damages and for completeness before the assembly. Installed
transport safety has to be removed.
The following conditions must be fulfilled to assemble the central lubrication pump to a complete machine
together with other parts without affecting safety and health of human:
Assemble the central lubrication pump in balance on site to ensure a safe operation. Observe the indicated data for
fastening drillings In the dimensional drawing. When selecting the installation area, ensure that the device is protected
against environmental and mechanic effects. For example also ensure a free access for lubricant refilling.
Special measurements concerning noise prevention or oscillation reduction do not need to be taken.
Connection for pressure switch
24
To Next Page
Loading...
Need help?
General
