Beko BP207C - Operation Introduction: Advanced Modes; Advanced Modes and Water Drainage

26 / EN
Local air-conditioner / User Manual
7.5 Heatng operaton (ths functon
s not avalable for a cold-sngle
unt)
– Press the “Mode” button tll the “Heat” con
appears.
– Press the “
∧
”or“
∨
” button to select a
desred room temperature. (16°C-31°C)
– Press the “Fan Speed” button to select
wnd speed.
7.6 Tmer operaton
Tmer On settng:
– When the ar-condtoner s Off, press the
“Tmer” button and select a desred ON
tme through the temperature and tme
settng buttons.
– “Preset On Tme” s dsplayed on the
operaton panel.
– On tme can be regulated at any tme n
1-24hours.
Tmer Off settng
– When the ar-condtoner On, press “Tmer”
button and select a desred Off tme through
the temperature and tme settng buttons.
– “Preset Off Tme” s dsplayed on the
operaton panel.
– Off tme can be regulated at any tme n
1-24hours.
7.7 Speed functon
Press the “Fan Speed” button to select wnd
speed.(hghspeed/lowspeed).
7.8 °C/°F functon
press the °C/°F button to swtch between Celsus
and Fahrenhet temperature dsplays.
(adjustment range: 16-31°C / 61-88°F).
7.9 Water danage
Water full alarm functon
The nner water tray n the ar-condtoner
has one water level safety swtches, t
controls the water level. When water level
reaches an antcpated heght, the water
full ndcator lghts up. When the water s
full, please remove the rubber blockage
from the dranage hole at the bottom of
unt, and dran all water outsde.
Contnuous dranage
– When you plan to leave ths unt unused
for a long tme, please remove the rubber
blockage from the dranage hole at the
bottom of unt, and dran all water outsde.
– You shall use the contnuous dranage wth
a dranage hose connected to the bottom
dran hole, when the unt workng at the
Heat or Dehumdfy mode.
– The contnuous dranage does not need
to be appled when the unt workng at
the Cool mode. The unt can evaporate the
condensate water automatcally by the
splash motor. Make sure the dranage holes
are stemmed well.
– If water splash motor s damaged,
contnuous dranage can be used. To
connect the dran hose to the bottom dran
hole (Fg.6), the unt can also work well.
– If splash motor s damaged, ntermttent
dranage can also be used. Under ths
condton, when the water full ndcator
lghts up, please connect a dran hose to
the bottom dranage hole, then all the
water n the water tank wll be draned
outsde. The unt can also work well.
7. Operaton ntroducton