Transmission
Change the Transmission Fluid and
Filters
Procedure described in Chapter 10, First 100
Hours Service.
Change the Transfer Case Oil
Procedure described in Chapter 10, First 100
Hours Service.
Hydraulics
Change the Return Filters
Procedure described in Chapter 10, First 100
Hours Service.
Pneumatic System
Change the Air Drier Filter (Unloader
Valve)
1. Drain the air reservoir to release the air pressure
in the system
2. Open the transmission cooler box lid to gain ac-
cess to the air drier filter.
3. Unscrew and remove the filter cartridge (1). Dis-
card the filter and O-ring, do not re-use.
4. Fit a new filter cartridge to the filter head with a
new O-ring. Smear a little oil on the new O-ring
before fitting
5. Tighten the air drier filter cartridge by hand and
then one half turn further.
6. Start the engine and when the air pressure has
reached normal operating pressure, check for
air leaks at the filter head.
Axles, Chassis and Driveshafts
Check the Bin Pivot Pins
Procedure described in Chapter 10, First 100
Hours Service.
92 870984-01
June 1, 1999
F000999
To Next Page
Loading...
Need help?
General
