116 870984-01
June 1, 1999
Wheel Trouble Shooting
Symptom Possible Cause Remedy
Wheel misalignment Wheel bent or damaged Change the wheel
Wheel cracked Impact damage Change the wheel
Overloading Change the wheel
Tyre Trouble Shooting
Symptom Possible Cause Remedy
Tyres wearing in tread centre Tyres over-inflated Reduce the tyre pressure to the cor-
rect level
Tyres wearing on both sides of the
tread
Tyres under inflated Increase the tyre pressure to the
correct level
Tyres loosing pressure Tyre punctured Repair the puncture or change the
tyre
Inflation valve defective Change the inflation valve
Cracks, splits or bulges in the tyre
sidewall
Impact damage Change the tyre
Defective tyre Change the tyre
Tyre over inflated Change the tyre
Tyre under inflated Change the tyre
Uneven tyre wear Incorrect alignment Check and adjust the alignment.
Contact your
BELL
Product Support
Representative
Deterioration of the tyre material Fuel or oil contamination Locate the source of contamination.
Change the tyre
Rapid tyre wear Excessive speed Instruct the operator on proper driv-
ing. Change the tyre
Poor road surface conditions Recommend road surface mainte-
nance. Change the tyre
Tyre component heat separation Excessive speed Instruct the operator on proper driv-
ing. Change the tyre
Tyre rubbing on the frame Wheel mis-aligned on the axle Inspect the tyre and change if nec-
essary. Check and adjust the wheel
and axle alignment
Cracks in the tyre tread grooves Incorrect tyre pressure Chance the tyre if separation occurs.
To Next Page
Loading...
Need help?
General
