14
The Power Unit can be located at either “X”
location shown below. It is important to
locate the POWERSIDE Runway (with Cyl-
inder) on the SAME SIDE as the power unit
location.
Utility Rails on the side of each Runway
MUST be installed to the inside.
For the remainder of this instruction we will
illustrate the Power Unit mounted at the
PASSENGER-SIDE (RIGHT) REAR Column -
TOP ILLUSTRATION.
For Power Unit at Left front, rotate lift 180°
leaving Approach Ramps and Front Tire
Stops in original position.
IMPORTANT NOTE:
POWER UNIT LOCATION
To Next Page
Loading...
