HD-973P Series Multi-Level Parking Lift 12 P/N 5900076 — Rev. B3 — January 2024
HD-973PX
Upper Platform Lower Platform
Lifting capacity 7,000 lbs. (3,175 kg) 9,000 lbs. (4,082 kg)
a – Length Overall (Platforms Lowered)
252.25 in (6,407 mm)
b – Total Width - Base Plates (outside to
outside)
110.5 ±.125 in. (2,809 ±3 mm)
c – Post Height
(3.25 in. max. for safety ladder adj.)
173.25 in. (4,400 mm)
d – Outside Posts Length - Base Plates
(outside to outside)
208.5 in. / (5,294 mm)
e – Posts (inside to inside)
100 in. (2,541 mm)
f – Maximum rise (upper platform)
151.5 in. (3,849 mm)
g – Maximum rise (lower platform)
82 in. (2,084 mm)
h – Runway Height – Down Position
10.75 in. (270 mm) N/A
i – Runway Height – Down Position
N/A 5 in. (128 mm)
j – Runway Width
19 in. (482 mm)
k – Distance between Runways
35 in. – 41 in. (887 mm –1,045 mm) Max.
l – Runway thickness (upper platform)
5.5 in. (137 mm) N/A
m – Runway thickness (lower platform)
N/A 4.75 in. (123 mm)
n – Drive through height (Top Lock)
2
79.25 in. (2,019 mm)
o – Drive through width (both platforms)
86.5 in. (2,201 mm)
p – Distance to Ramp (upper)
122 in. (3,097 mm)
q – Distance to Ramp (lower)
63 in. (1,605 mm)
r – Runway Length
192.75 in. (4,898 mm) 176 in. (4,473 mm)
Min. wheelbase @ rated capacity
1
135 in. (3,429 mm) 125 in. (3,175 mm)
Min. wheelbase @ 75% capacity
1
120 in. (3,048 mm) 110 in. (2,794 mm)
Min. wheelbase @ 50% capacity
1
100 in. (2,540 mm) 90 in. (2,286 mm)
Min. wheelbase @ 25% capacity
1
80 in. (2,032 mm) 75 in. (1,905 mm)
Top Safety Lock (top of Platform) 156 in. (3,962 mm) 84.5 in. (2,145 mm)
Safety Lock Positions 34 every 4 in. (102 mm) 16 every 4 in. (102 mm)
Lifting time 90 seconds 50 seconds
Motor 110 or 220 VAC, 60 Hz, 1 Ph (special voltages available)
1
The Runways support less weight than their rated capacity as the Vehicle wheelbase reduces. Vehicles with a short
wheelbase have wheels closer to the middle of the Runway, where there is less strength. For example, the maximum
weight permitted on the Top Platform for a Vehicle with a wheelbase of 95 in. is 50 percent of the full rated capacity or
3,500 lbs.
2
All measurements are taken with the Safety Ladders adjusted to their upper maximum.
Important: All posts include fasteners extending horizontally ≈.65 in. (16.5 mm) on all four posts. This larger
dimension should not be used to create the chalk lines for Lift installation, but additional clearance
around the Posts is required.
Specifications subject to change without notice.
To Next Page
Loading...
