MD-6XP Mid-Rise Scissor Lift 19 P/N 5900108 — Rev. F — March 2020
4. Attach a Hydraulic Straight Fitting (NPL 04 JIC – 04 NPT) to the outside Hydraulic Port of the
Hydraulic Cylinder closest to where the Power Unit will be.
5. Route the Straight end of the Long Hydraulic Hose through the opening in the Frame, and then
connect it to the Straight Fitting.
6. On the Power Unit, remove the Shipping Plug from the Hydraulic Out Port you want to use; it does
not matter which one you use.
The following drawing shows the possible port configurations, depending on your Power Unit.
Hydraulic Out Ports are usually labeled P on the Power Unit. Not all components of the Power Unit
are shown. Not drawn to scale.
7. Attach a Hydraulic Elbow Fitting (04 JIC – 06 ORB) to the Hydraulic Out Port.
8. Connect the Curved end of the Long Hydraulic Hose to the Elbow Fitting on the Power Unit.
Once all Hoses and Fittings have been attached, securely tighten all connections.
To Next Page
Loading...
