BendPak MD-6XP - Page 23

MD-6XP Mid-Rise Scissor Lift 23 P/N 5900108 — Rev. F — March 2020
Install a Thermal Disconnect Switch
⚠ WARNING The motor on the Power Unit supplied with your Lift has no thermal overload
protection.
Have the Electrician connect a motor Thermal Disconnect Switch or overload device that will make
sure the equipment shuts down in the event of an overload or an overheated motor.
⚠ DANGER Installing a Thermal Disconnect Switch must be performed by a licensed, certified
Electrician. Do not perform
any maintenance or installation on the Lift without first
making sure that main electrical power has been disconnected from the Lift and
cannot be re-energized until all procedures are complete.
High running amps that exceed the motor’s full load amps (FLA) rating may result in permanent
damage to the motor.
BendPak strongly recommends you
not exceed the rated duty cycle of the motor.