BendPak MD-6XP - Page 30

MD-6XP Mid-Rise Scissor Lift 30 P/N 5900108 — Rev. F — March 2020
8. On the front of the Power Unit, press and hold the Up Button to raise the Lift until just before the
Lifting Arms make contact with the Lifting Points.
9. Check to make sure the Lifting Arms will make solid contact with the Lifting Points when raised
further.
Adjust them if necessary.
10. Raise the Lift until the tires of the Vehicle are a few inches off the ground.
If the Lift becomes unstable or the Vehicle starts moving, release the Up Button immediately.
11. Check to make sure the Lift Arms are making solid contact with the Lifting Points.
If any of the Lift Pads are not making solid contact with the Lifting Points, lower the Lift and adjust
the Lift Pads so that they make better contact.
12. Rock the Vehicle to make sure the Vehicle is stable and balanced.
If the Vehicle is
not stable and balanced, lower the Lift back to the ground and start over.
If the Vehicle
is stable and balanced, it is safe to raise further.
⚠ DANGER Do not raise the Lift further until you are certain the Vehicle on the Lift is both stable
and balanced. If the Vehicle is
not stable and balanced, it could fall, which could
damage the Vehicle, damage the Lift, or injure or kill anyone under the Vehicle.
13. On the Power Unit, press and hold the Up button.
14. When the Lift just passes the desired height, release the Up button.
15. Hold the Lowering Handle briefly to move the Lift back down, which engages it on the most
recently passed Safety Lock.
If you miss the desired Safety Lock, press and hold Up again and go for somewhat further past the
desired Safety Lock. Release Up, then hold the Lowering Handle again to lower the Platform onto
the desired Safety Lock.