P-9000LT/F Low-Rise Pit Lift 26 P/N 5900022 — Rev. B — Nov. 2019
Connect the Hydraulic Hoses: 110 VAC Setup Only
The 110 VAC Power Units that are available for the P-9000LT/F use a different Hydraulic Hose setup
than the standard 208-240 VAC Power Units. This section covers the 110 VAC Power Unit setup.
The standard 208-240 VAC Power Unit Hydraulic Hose setup is described in Connect the
Hydraulic Hoses.
If you ordered a 110 VAC Power Unit with the P-9000LT/F, then the Lift came with one Short Hydraulic
Hose and two Long Hydraulic Hoses. These should be configured as shown below.
Fittings shown not connected for clarity. Drawing not to scale.
Important: The Hydraulic Hose Assemblies need to be installed up against, or very near to, the
Hydraulic Cylinders.
To connect the Hydraulic Hoses:
1. If the Platforms are not already on their top Safety Locks, raise them now and engage them on
their top locks. It is not possible to connect the Hydraulic Hoses if the Platforms are lowered.
Refer to Lift the Platforms Off the Bases for additional information.
2. Locate the Flow Divider, Hydraulic Elbow Fittings, Hydraulic Hoses, and Hydraulic Hose
Assemblies.
3.
On the Power Unit
, attach an Hydraulic Elbow Fitting to one of the two Hydraulic Power Out
connectors on the Power Unit; these are labeled P1 and P2, you can use either one.
4. Connect the Short Hydraulic Line to the Hydraulic Elbow Fitting you just attached.
To Next Page
Loading...
