PL-12000DP Series Parking Lift 5 P/N 5900285 — Rev. A1 — February 2023
Shipping Information
Your equipment was carefully checked before shipping. However, you should thoroughly inspect the
shipment
before
you sign to acknowledge that you received it.
When you sign a bill of lading, it tells the carrier that the items on the invoice were received in good
condition.
To protect yourself, do not sign until after you have inspected the shipment.
If any of
the items listed on the bill of lading are missing or are damaged, do not accept the shipment until the
carrier makes a notation on the bill of lading that lists the missing and/or damaged goods.
If you discover missing or damaged goods
after
you receive the shipment and have signed the bill of
lading, notify the carrier at once and request the carrier to make an inspection. If the carrier will not
make an inspection, prepare a signed statement to the effect that you have notified the carrier (on a
specific date) and that the carrier has failed to comply with your request.
It is difficult to collect for loss or damage after you have given the carrier a signed bill of lading. If this
happens to you, file a claim with the carrier promptly. Support your claim with copies of the bill of
lading, freight bill, invoice, and photographs, if available. Our willingness to assist in helping you
process your claim does not make us responsible for collection of claims or replacement of lost or
damaged materials.
Safety Considerations
Read this entire manual carefully before using your new product.
Do not install or
operate the product until you are familiar with all operating instructions and warnings. Refer to
ANSI/ALI ALIS Standard Safety Requirements for Installation and Service of Automotive Lifts for more
information about safely installing your Lift.
⚠ WARNING California Proposition 65. This product can expose you to chemicals
including styrene and vinyl chloride which are on the list of over 900 chemicals
identified by the State of California to cause cancer, birth defects or reproductive
harm. ALWAYS use this product in accordance with BendPak BendPak’s
instructions. For more information go to www.P65Warnings.ca.gov.
Important Safety Instructions!
SAVE THESE INSTRUCTIONS!
1. Read all instructions.
2. Care must be taken as burns can occur from touching hot parts.
3. Do not operate equipment with a damaged cord or if the equipment has been dropped or
damaged – until it has been examined by a qualified service person.
4. Do not let a cord hang over the edge of a table, bench, or counter or come in contact with hot
manifolds or moving fan blades.
5. If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment should be used. Cords with a current rating less than the equipment may overheat.
Care should be taken to arrange the cord so that it will not be tripped over or pulled.
6. Always unplug the equipment from the electrical outlet when not in use. Never use the cord to pull
the plug from the outlet. Grasp the plug and pull to disconnect.
7. Let equipment cool completely before storing. Loop cord loosely around unit when not in use.
To Next Page
Loading...
