EasyManua.ls Logo

BendPak PL-12000DP - Symbols and Liability; Safety Symbols Guide; BendPak Liability Information

Default Icon
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PL-12000DP Series Parking Lift 7 P/N 5900285Rev. A1 — February 2023
determine the extent of the injury. Explain the circumstances of the injury to the attending
physician, including what kind of Hydraulic Fluid was involved.
Do not assume a puncture
wound that could have been caused by Hydraulic Fluid is a minor issue; it could
be life threatening.
32. Make an inspection of the Lift
before
using it. Check for damaged, worn, or missing parts. Do not
use it if you find any of these issues. Instead, take it out of service, then contact an authorized
repair facility, your dealer, or BendPak at (877) 432-6627 or support@BendPak.com.
WARNING
Chock Wheels
to reduce the risk of property damage, personal injury, or loss of
life.
NEVER
park any vehicle on the Lifts runways without placing two suitable
Wheel Chocks
behind each rear tire so that the vehicle cannot roll backward
from Lift. Vehicles parked on Lift
MUST
also be placed in Park or First Gear
(Manual Transmission) with the Parking Brake fully applied.
Symbols
Following are the symbols used in this manual:
DANGER Calls attention to an immediate hazard that will result in injury or death.
WARNING Calls attention to a hazard or unsafe practice that could result in injury or death.
CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help to use the product better.
Liability Information
BendPak Inc. assumes no liability for damages resulting from:
Use of the product for purposes other than those described in this manual.
Modifications to the equipment without prior, written permission from BendPak Inc.
Injury or death caused by modifying, disabling, overriding, or removing safety features.
Damage to the equipment from external influences.
Incorrect operation of the equipment.

Related product manuals