5
INSTALLER / OPERATOR
PLEASE READ AND FULLY
UNDERSTAND.
BY PROCEEDING YOU AGREE TO
THE FOLLOWING:
t I have visually inspected the site where the lift is to
be installed and veried the concrete to be in good condi-
tion and free of cracks or other defects. I understand that
installing a lift on cracked or defective concrete could
cause lift failure resulting in personal injury or death.
t I understand that a level oor is required for proper
installation and level lifting.
t I understand that I am responsible if my oor is of
questionable slope and that I will be responsible for all
charges related to pouring a new level concrete slab if
required and any charges.
t I understand that Bendpak lifts are supplied with
concrete fasteners meeting the criteria of the American
National Standard “Automotive Lifts - Safety Requirements
for Construction, Testing, and Validation” ANSI/ALI
ALCTV-2011, and that I will be responsible for all charges
related to any special regional structural and/or seismic
anchoring requirements specied by any other agencies
and/or codes such as the Uniform Building Code (UBC)
and/or International Building Code (IBC).
t I assume full responsibility for the concrete oor and
condition thereof, now or later, where the above equip-
ment model(s) are to be installed. Failure to follow danger,
warning, and caution instructions may lead to serious per-
sonal injury or death to operator or bystander or damage
to property.
t I understand that BendPak lifts are designed to be
installed in indoor locations only. Failure to follow instal-
lation instructions may lead to serious personal injury or
death to operator or bystander or damage to property or
lift.
Failure to follow danger, warning, and caution
instructions may lead to serious personal injury or death
to operator or bystander or damage to property.
Please read entire manual prior to installation. Do not
operate this machine until you read and understand
all the dangers, warnings and cautions in this manual.
For additional copies or further information, contact:
BendPak Inc. / Ranger Products
1645 Lemonwood Dr.
Santa Paula, CA. 93060
1-805-933-9970
www.bendpak.com
INSTALLER / OPERATOR
PROTECTIVE EQUIPMENT
Personal protective equipment helps makes installa-
tion and operation safer, however, it does not take the
place of safe operating practices. Always wear durable
work clothing during
any installation and/or
service activity. Shop
aprons or shop coats
may also be worn, how-
ever loose tting cloth-
ing should be avoided.
Tight tting leather gloves are recommended to protect
technician hands when handling parts. Sturdy leath-
er work shoes with steel toes and oil resistant soles
should be used by all service personnel to help prevent
injury during typical installation and operation activities.
Eye protection is essential during installation and opera-
tion activities. Safety glasses with side shields, goggles,
or face shields are acceptable. Everyday eyeglasses only
have impact resistant lenses, they are not safety glasses.
Back belts provide support during lifting activities and are
also helpful in providing worker protection. Consideration
should also be given to the use of hearing protection if
service activity is performed in an enclosed area, or if
noise levels are high.
THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH IF NOT FOLLOWED
COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OR YOURSELF AND OTHERS
AND CAN CAUSE PERSONAL INJURY OR DEATH. READ AND FOLLOW ALL INSTRUCTIONS IN
THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
To Next Page
Loading...
Need help?
General
