29
How to assemble your monitor hardware (for
models without height adjustment stand)
• If the computer is turned on you must turn it off before continuing.
• Do not plug-in or turn-on the power to the monitor until instructed to do so.
• The illustrations in this document are for your reference only and may look different from the
appearance of the product.
• The following illustrations are for your reference only. The location and available input and output
jacks may vary depending on the purchased model.
• Avoid finger pressure on the screen surface.
• The latch on the monitor stand/base of the same model may vary by design, yet the installation,
function, and product appearance are not affected in general. Be sure to assemble the monitor with
the stand/base in the same package.
1. Attach the monitor stand and base.
Please be careful to prevent damage to the monitor. Placing the screen surface on an object like a
stapler or a mouse will crack the glass or damage the LCD substrate voiding your warranty. Sliding or
scraping the monitor around on your desk will scratch or damage the monitor surround and controls.
Protect the monitor and screen by clearing a flat
open area on your desk and placing a soft item like
the monitor packaging bag on the desk for
padding.
Gently lay the screen face down on a flat clean
padded surface.
Attach the monitor stand to the monitor base as
illustrated until it locks in place.
Pay attention to the sharp parts during assembly.
To Next Page
Loading...
Need help?
General
