Playback mode 25
English
• Press to stop the video clip, or press to pause it. Press again to
resume.
Adjusting the playback volume
Increase or decrease the volume of video clips, audio clips, or voice memos.
To adjust the playback volume:
1. Turn the power on, and set the camera to the playback mode.
2. Press or to select a video clip, audio clip, or voice memo that you want to playback.
3. Adjust the volume.
• Press to increase the volume.
• Press to decrease the volume.
The volume can be set during playback, but not during rewind/fast forward/pause.
Slideshow
Sets the time interval for presenting a series of captured image and video files (first frame
only).
To play a slideshow:
1. Press > > > Slideshow > or .
2. Change the slideshow settings.
• Use the four-way control to set one of the following slideshow effects:
• Applies a transition effect from left to right.
• Applies a transition effect from upper-left side to lower-right side.
• Applies a horizontal transition effect.
• Applies a vertical transition effect.
• Applies a horizontal transition effect by intersecting an image.
• You can set the interval between 1/3/5/10 seconds.
3. Select whether you want to repeat the slideshow.
4. Select Start and press to play the slideshow.
If you want to pause it at any time, press . Press again to resume playback. To
stop the slideshow, press .
• During video playback, press to fast forward or press to rewind.
• While pausing video playback, you can press the shutter to capture the video frame as
a still image in the VGA format.
• While pausing video playback, you can view the video frame by frame. Press to fast
forward one frame, or press to rewind one frame. Press and hold to fast
forward frame by frame continuously, or press and hold to rewind frame by frame
continuously.
C1250_C1255_UM - EN.book Page 25 Friday, March 26, 2010 1:33 PM
To Next Page
Loading...
Need help?
General
