Operation
34
Renaming user modes
You can change User 1 and User 2 to the names easy to be identified or understood
by the users of this projector. The new name can be up to 12 characters including
English letters (A-Z, a-z), digits (0-9), and space (_).
To rename user modes:
1. Make sure the Menu Type is Advanced. See "Using the menus" on page 25 for
details.
2. Go to the Picture > Picture Mode > User 1 or User 2 menu.
3. Go to the User Mode Management > Rename User Mode and press OK
on the projector or remote control.
4. Press / to select the item you want to rename and press OK on the projector
or remote control. The first letter will be highlighted by a white box.
5. Press / to select the first character.
6. Press to move along until the new name is set and press
OK on the projector
or remote control
to confirm.
7. Repeat steps 4-6 if you want to change the other names.
Resetting current picture mode
All of the adjustments you’ve done in the Advanced menu > Picture menu (except for
the User Mode Management) can be returned to the factory preset values with a key
press on the selection of Reset.
To reset the picture mode to the preset factory values:
1. In the Picture menu, select Picture Mode and press / to select the picture
mode (including User 1 or User 2) you want to reset.
2. Press to select Reset Current Picture Mode and press
OK on the projector
or remote control
. The confirmation message displays.
3. Press / to select Reset and press
OK on the projector or remote control.
The picture mode will return to the factory preset settings.
4. Repeat steps 1-3 if you want to reset other picture modes.
Do not to be confused with the Reset Current Picture Mode function here with the
Reset All Settings (which is in the Basic menu when the projector is without input
signal or in the Advanced menu > System Setup: Advanced menu). The Reset All
Settings function returns most of the settings to the factory preset values system
wide. See "Reset All Settings" on page 56 for details.
Using Wall Color
In the situation where you are projecting onto a colored surface such as a painted wall
which may not be white, the Wall Color feature can help correct the projected
picture’s color to prevent possible color difference between the source and projected
pictures.
To use this function, go to the Advanced menu > Display > Wall Color menu and
press / to select a color which is the closest to the color of the projection
surface. There are several precalibrated colors to choose from: Light Yellow, Pink,
Green and Blue.
To Next Page
Loading...
