Maintenance
64
11. Restart the projector.
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
12. After the startup logo, open the On-
Screen Display (OSD) menu. Go to the
Advanced menu > System Setup:
Advanced > Lamp Settings > Reset
Lamp Timer menu and press OK on
the projector or remote control. A
warning message displays asking if you want to reset the lamp timer. Highlight
Reset and press OK. The lamp time will be reset to '0'.
Do not reset if the lamp is not new or replaced as this could cause damage.
9. Replace the lamp cover by sliding it
into place.
10. Tighten the screw that secures the
lamp cover.
• Loose screw may cause a bad
connection, which could result in
malfunction.
• Do not over tighten the screw.
(b)
(a)
To Next Page
Loading...
