BenQ W2000+ - Page 31

Menu Functions
31
• Wall Color
Enable this function to help correct the projected picture’s color when the projection
surface is not white. You may choose a color similar to that of the projection surface
from these options: Light Yellow, Pink, Light Green, or Blue.
• Projector
Position
The projector can be installed on a ceiling or behind a screen, or with one or more
mirrors. See
Choosing a location for details.
• Test Pattern
Enable this function to display the grid test pattern, which helps you adjust the image
size and focus so as to check if the projected image is free of distortion.
• Auto Source
Sets whether the projector searches automatically for input sources. Select On to
enable the projector to scan for input sources until it acquires a signal. If the function
is set to Off, the projector selects the last used input source.
• Menu Type
Switches to the Advanced OSD menu.
• HDMI
Format
Selects an input source type for the HDMI signal. You can also manually select the
source type. The different source types carry different standards for the brightness
level.
HDMI Format is only available when the HDMI signal is selected.
• Reset Lamp
Timer
Activate this function only after a new lamp is installed. When you select Reset, a
"Reset Successfully" message is displayed to notify that the lamp time has been
reset to "0".
• Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, Rename User Mode, L/R
Switch, Language, Projector Position, Menu Type, Source Rename, Reset Lamp
Timer, Test Pattern, High Altitude Mode, Password, Key Lock, and ISF.
• Information
Displays the following information about your projector.
• Source: Displays the current signal source.
• Picture Mode: Displays the current Picture Mode.
• Resolution: Displays the native resolution of the input source.
• Color System: Displays input system format.
• Lamp Usage Time: Displays the number of hours the lamp has been used.
• 3D Format: Displays the current 3D mode.
3D Format is only available when 3D Mode is enabled.
• Firmware Version: Displays the firmware version of your projector.
Some information is given only when certain input sources are in use.