BenQ W2000+ - Audio Setup Menu; Sound Mode and EQ Configuration; Volume and Mute Control

38
Menu Functions
Reset Current
Picture Mode
All of the adjustments you’ve made for the selected Picture Mode (including preset
modes, User 1, and User 2) return to the factory preset values.
1. Press OK. The confirmation message is displayed.
2.
Use / to select Reset and press OK. The picture mode returns to the
factory preset settings.
3. Repeat steps 1 and 2 if you want to reset other picture modes.
Audio Setup menu
Submenu
Functions and Descriptions
Sound Mode
• Effect Mode
Sound Mode function utilizes MaxxAudio sound enhancement technology, which
incorporates Waves’s algorithms to deliver great effects of the bass and treble and
provide you with immersive cinematic audio experience. The following preset sound
modes are provided: Standard, Cinema, Music, Sport, Game, and User.
The User mode allows you to personalize the sound settings. When selecting the
User mode, you may make manual adjustments with the User EQ function.
If the Mute function is activated, adjusting Sound Mode will turn off the Mute
function.
• User EQ
Select desired frequency bands (100 Hz, 300 Hz,1k Hz, 3k Hz, and 10k Hz) to adjust
the levels according to your preference. The settings made here define the User
mode.
Mute
Select On to temporarily turn off the projector's internal speaker or the volume
being output from the audio output jack.
To restore the audio, select Off.
The function is accessible through the remote control.
Volume
Adjusts the volume level of the projector's internal speaker or the volume being
output from the audio output jack.
If the Mute function is activated, adjusting Mute will turn off the Mute function.
The function is accessible through the remote control.
L/R Switch
(W2000+ only)
The setting of this function changes by your choice of Projector Position.
When you choose Front or Rear Ceiling for the Projector Position, it will be
Off. That is the left and right audio channels of the projector will not automatically
swap.
When you choose Front Ceiling or Rear for the Projector Position, it will be
On. Then the left and right audio channels will automatically swap.
However, if you want to change the user scenario defined above, you can select On/
Off to turn on/off this function under any setting of Projector Position.
Power On/Off
Ring Tone
Sets the ring tone for the projector On or Off.
The Power On/Off Ring Tone can only be adjusted here. Setting the sound
mute or adjusting the sound level do not affect the Power On/Off Ring Tone.
Reset Audio
Settings
All of the adjustments you’ve done under the Audio Setup menu return to the
factory preset values.