Repeaters A disabled Repeater cannot command the Control panel, although, its di-
splay will show the panel status. Loss of a disabled Repeater from the Net-
work will not generate FAULT status.
Ø To clear a FAULT status - generated by the loss of a Repeater - Disable
the Repeater in question.
+
FAULT status will be generated when the Repeater (in FAULT status) is
re-enabled.
Procedure Procced as follows to disable the control panel Items: Loop Devices; Bell
Outputs; Software Zones; Network Devices.
A Select the Disable option from the MODI-
FYING menu (press 1).
B Select the Item, or press ESC to step back
to the MODIFYING menu.
C
Enter the Item address then press the ↵.
key, or press ESC to step back and select
another Item.
If a valid address is entered the display will show: the Item label; real-time
Analogue Value; type; address; current status (see figure 4).
D
Press the ↑ or ↓ key to change the Item
status then press the ↵ key to confirm or
ESC to quit.
E Step back to C.
Modifying:
1=Disable
2=Del.Ver. 3=Del.Log
4=Telecom Module
MOD: Enab./Disabl.
1=LOOP 1
2=Outputs BELL
3=ZONES 4=NET
MOD: Devices L1
Enter Address
Sensors L1: 1/##
Modules L1: 1/__
MOD: Enab./Disabl.
Device: SENSOR
%## 1/##
STATUS: DISABLED
MODIFYING 23
To Next Page
Loading...
