46
Multifunction Control Panel
Changing
Keys/Cards
Programming Keys and Cards
1. To program a new Key/Card, enter Parameter Number 5000, then press
E. The X indicator will turn ON.
2. Enter the ID Number of the Reader you intend to use (accepted entries: 1
through 16), then press
E. The S indicator will turn ON.
ATTENTION - The Reader must be enrolled on the system, and must be in
standby status before starting the Key/Card programming session.
3. Using
1 (SERVICE), 2 (RESET CALL QUEUE), 3 (AND) and/or 4
(PATROL) set up the Key/Card Options, then press E to confirm and
continue (
T indicator ON), or press e to abort the setting and step back.
4. Using keys
1 to 4, enable/disable the Key/Card on the respective Parti-
tion (refer to Tab. 16 for details), then press
E to continue, or e to
step back.
5. Hold the Key/Card near the sensitive field of the Reader, or insert the key
into the Reader. Successful enrolling will be indicated by:
a) a long beep;
b) the
V indicator (ON);
c) the Binary Code of the respective Key/Card ID Number on the Keypad.
If enrolling fails, the Reader will emit an audible error signal, and all the
backlit keys will turn OFF.
NOTE: The DECIMAL – BINARY Conversion Table can be found at the
end of this Manual.
Repeat the procedure for each of the system Key/Cards.
6. Press e to step back.
1. To change a Key/Card, enter a Parameter Number from 5001 — 5128 (refer
to Tab. 16 for details), then press
E.
2. Using
1 (SERVICE), 2 (RESET CALL QUEUE), 3 (AND) and/or 4
(PATROL) change the Key/Card options. If the Key/Card has been
properly enrolled, key
7 (LED 3) will light. To unenrol the Key/Card,
press
8. The Key/Card will be unenrolled when the programming session
ends.
3. Press
E to go to the next step.
4. Using keys 1 to 4, enable/disable the Key/Card on the respective Parti-
tion (refer to Tab. 16 for details), then press
E to continue, or e to
step back.
Programming
New Keys/Cards
To Next Page