5
Introduction
INTRODUCTION
You can program the system using the ‘KyoUnit’ Software Application and a compu-
ter (refer to the “INSTALLATION MANUAL”). You can also program some models
from the KYO range via an LED Keypad (refer to the following Table).
This manual contains instructions regarding programming via Keypad. For
information regarding the system parameters, refer to ‘PROGRAMMING
FROM PC’ in the ‘INSTALLATION MANUAL’.
Code Limitations
The INSTALLER Code can program the system but cannot program the PINS
of the 24 User Codes.
MAIN USER Codes can program the PINs of User Codes (but not other Main
User Codes) which operate on the Partitions they are assigned to.
In the Table below, Code 1 is a Main User Code assigned to Partitions 1, 3 and 4.
Therefore, it can program its own PIN (Code 1) and the PINs of: User Code 3
(assigned to Partitions 1 and 3), User Code 4 (assigned to Partition 4), User Code
5 (assigned to Partitions 3 and 4) and User Code 7 (assigned to Partition 3).
Code 2 is a Main User Code assigned to Partitions 2 and 3. Therefore, it can
program its own PIN, and the PINs of: Code 6 (assigned to Partition 2), User
Code 7 (assigned to Partition 3), User Code 8 (assigned to Partitions 2 and 3).
To Next Page
Loading...
