Bentel Security KYO 32 - Setting up the Outputs

35

Programming from the LED Keypad
Setting up the Outputs
1. Enter a Parameter Number from 191 – 210 (refer to Tab. 8 for details), then
press
E.
2. Using keys
1 to 8, enable the required Activation Signal (refer to Tab.
8 for details).
3. Press E to confirm, or e to abort the setting.
1. Enter a Parameter Number from 211 – 215 (refer to Tab. 8 for details), then
press E.
2. Using keys 1 to 4, enable the Output on the Partitions (refer to Tab. 8
for details).
3. Press
E to confirm, or e to abort the setting.
Assigning Partitions