9
Programming from the LCD Keypad
The Installer’s Code will allow you to access the INSTALLER MENU and
program the following options:
Actions (Event Logger, Zones Status, Test Siren, Clear Call Queue)
Zones
Outputs
Times (Entry/Exit Times)
Inst.Cod (Installer Code)
Keys (Key/Card and Wireless)
Codes (User Codes)
Readers (Key/Card Readers)
Keypads (Keypads and Language)
Date/T. (Date and Time)
Timers (Scheduler)
Teleph. (Telephone numbers)
Teleser. (Teleservice)
Test Ev. (Test Call)
Events
Options
Strings (Descriptions)
Default (Restore Factory Default)
Exp. IN (Expander IN) — ONLY Series 32 Models
Exp. OUT (Expander OUT) — ONLY on Series 32 Models
All Partitions must be disarmed before starting the programming session.
If the system operates with LED Keypads only — before starting the Pro-
gramming session, enrol an LCD Keypad at Address 8 (refer to “Enrolling an
LCD Keypad at address 8”).
To start the Programming session:
1. From Standby status, enter the Installer code
(
0025 at Default), then press
EE
EE
E.
2. Select the required option from the PROGRAM-
MING Menu.
Once PROGRAMMING has been accessed, the
Control panel will:
a) lock all Keypads, except for the one in use;
The locked Keypads will show the
“
PROGRAMMING ” message, and all the indicators
(I, a and G) will turn OFF.
Customizing the System
Installer Menu Options
Input
Code *-----
PROGRAMMING
Actions âá
Accessing the
Installer Menu
PROGRAMMING
PROGRAMMING FROM THE LCD KEYPAD
To Next Page