Bentel Security KYO 32 - Enrolling an LCD Keypad at Address 08; Adjusting Contrast, Brightness and Volume

7

Introduction
Enrolling an LCD Keypad at Address 08
To enrol an LCD Keypad at Address 08 from a LED Keypad, enter:
<Installer Code> +
OO
OO
O
A short beep will indicate that the LCD Keypad has been enrolled.
NOTE - You must enrol the LCD Keypad at Address 8 (using DIP switches
[51]), before completing the connection (refer to Table 2.1 or 2.2 in the IN-
STALLATION MANUAL).
The following procedure will allow you to change the Kyo Control panel
parameters when:
 The Programming Software is not available.
 A system, previously programmed via an LCD Keypad, must be repro-
grammed via an LED Keypad.
 The system is equipped with LED Keypads only.
Before ending the Programming session, you must DISABLE the Keypad at
Address 8 or re-enable the LED Keypad (refer to the “Keypads” paragraph in
this section).
Adjusting Contrast, Brightness and Volume
NOTE - For MIA, ALISON/S and ALISON/DVP only.
You can change the Display Contrast and Brightness, and the Buzzer Volume.
Changes can be made during Standby status only.
z Brightness Press and hold
AA
AA
A (or A) to turn the Brightness up
Press and hold
BB
BB
B (or B) to turn the Brightness down
z Contrast Press and hold
CC
CC
C (or C) to turn the Contrast up
Press and hold
DD
DD
D (or D) to turn the Contrast down
z Volume You can select 3 volume levels: High, Medium and Mute.
Press
ee
ee
e (or e ) until you obtain the required Volume level.
 Long high Beep = High Volume
 Long low Beep = Average Volume
 Short low Beep = Mute