45
Programming from the LED Keypad
Programming the
Installer Code
Code Type
Codes
1. Enter a Parameter Number from 463 – 693 (refer to Tab. 15 for details),
then press
E.
2. Using keys
1 to 3, define the Code Type (refer to Tab. 15 for de-
tails).
3. Press E to confirm, or e to abort the setting.
1. Enter a Parameter Number from 464 – 694 (refer to Tab. 15 for details),
then press
E.
2. Using keys 1 to 4, enable/disable the Code on the Partitions (refer to
Tab. 15 for details).
3. Press
E to confirm, or e to abort the setting.
1. Enter a Parameter Number from 465 – 695 (refer to Tab. 15 for details),
then press
E.
2. Using keys
1 to 4 (Partitions 1 to 4 respectively ) set up the A
Arming Mode for the Code (refer to Tab. 15 for details).
NOTE: The Reader will not accept “Z” Mode (Stay with 0 Delay).
3. Press
E to confirm, or e to abort the setting.
1. Enter a Parameter Number from 469 – 699 (refer to Tab. 15 for details),
then press
E.
2. Using keys
1 to 4 (Partitions 1 to 4 respectively ) set up the B
Arming Mode for the Code (refer to Tab. 15 for details).
NOTE: The Reader will not accept “Z” Mode (Stay with 0 Delay).
3. Press
E to confirm, or e to abort the setting.
1. Enter Parameter Number 457, then press
E.
2. Enter the New Installer Code, then press
E.
Options for Type A
Arming Mode
Options for Type B
Arming Mode
Enabled Partitions
To Next Page