Need help?Do you have a question about the Bentel Security Base-2 and is the answer not in the manual?
General| Brand | Bentel Security |
|---|---|
| Model | Base-2 |
| Category | Security System |
| Language | English |
Lists the key functionalities and capabilities of the Base-2 Security Panel.
Details the components and LEDs on the front panel of the Base-2.
Identifies and describes the internal electronic components of the Base-2 panel.
Provides an overview of the internal layout and components of the Base-2 panel.
Details the components and connections for external key and proximity readers.
Step-by-step guide for physically mounting the Base-2 security panel.
Instructions for installing key readers, including flush mounting options.
Guide for installing proximity readers, including connection and addressing.
Explanation of the function and connection of each terminal on the Base-2 panel.
Details wiring and addressing for connecting key and proximity readers.
Wiring instructions for connecting various types of sensors to the panel.
Guide for wiring outdoor sirens to the panel's alarm output.
Guide for wiring indoor sirens to the panel's alarm output.
Instructions for connecting a telephone dialler for remote notifications.
Wiring procedure for the tamper detection line for security.
Explains the connection of other peripheral devices via open-collector outputs.
Details the procedures for configuring various panel functions via DIP switches.
Configures the duration of the alarm signal before it silences.
Sets whether alarms are single cycle or repetitive.
Configures Zone 1 to have a delayed entry or be instant.
Sets the delay periods for entering and exiting the secured area.
Configures the input type for zones (NC or 10K Balanced).
Determines how the indoor siren signals alarms (bypassed or not).
Controls whether proximity readers emit audible feedback.
Process for registering key readers and card readers to the system.
Procedure for registering digital keys and proximity cards for system access.
Steps to remove registered digital keys and proximity cards from the system.
Instructions on how to safely open the panel after initial installation.
Procedure to reset the system to its factory default configuration.
Overview of system control operations via panel or remote devices.
Instructions for operating the system directly from the main panel.
How to arm and disarm the entire security system using the panel.
Procedure for bypassing specific zones for partial arming.
How to silence active alarms on the system.
How to clear the system's record of past alarm events.
Instructions for operating the system using digital keys or proximity cards.
How to cancel an arming sequence if initiated incorrectly.
Steps to arm the system using a key or card reader.
Steps to disarm the system using a key or card reader.
How to bypass zones using a key reader.
How to bypass zones using a proximity reader.
How to silence alarms using a key or card reader.
How to clear alarm memory using a key reader.
Explanation of the time delays for entering and exiting the protected area.
Explains the exit delay period when arming the system.
Explains the entry delay period when disarming the system.
Describes the system behavior when an invalid key is used.
Explains the 'System Busy' status when multiple requests occur.
Explains the meaning of LED indicators on key and proximity readers.
To Next Page
