Alarm Channel 2 Short Message - Brief Dedicated Channel 2 Message
The alarm channel 2 message is sent to the programmed telephone num-
bers when the alarm channel 2 cycle is triggered.
Record To record the alarm channel 2 message follow the entire recording proce-
dure for the alarm channel 1 message, but at step 3 press key 2.
+
If option "1" is programmed as "Long Common Message" (common to both
channels), it will not be possible to record a message for channel 2.
+
If option "1" is programmed as "Two Dedicated Messages" the maximum
recording time will be 16 seconds.
+
If option "1" is programmed as "Short Common Message + 2 brief dedi-
cated messages" the maximum recording time will be 8 seconds.
Playback To playback the alarm channel 2 message/s follow the entire playback pro-
cedure for the alarm channel 1 message/s, but at step 2 press key 2.
Short Common Message
If option "1" is programmed as "Short Common Message + 2 brief dedicated
messages", the Short Common Message will be sent to the programmed tele-
phone numbers, in the event of an alarm on either alarm channel 1 or 2.
Record To record the "Short Common Message" follow the recording procedure of
the alarm channel 1 message, but at step 3 press key 3.
+
If option "1" is programmed as "Long Common Message" (common to both
channels) or "Two Dedicated Messages", it will not be possible to access
this phase.
+
If option "1" is programmed as "Short Common Message + 2 brief dedi-
cated messages", the maximum recording time will be 16 seconds.
Playback To playback the "Short Common Message" follow the playback procedure
of the alarm channel 1 message, but at step 2 press key 3.
User Command PIN
The User Command PIN can stop the programmed B-TEL99 call cycle/s
during an alarm status, and can be used on the B-TEL99 keypad and on
the kepad of the telephone called by B-TEL99 (see "Stop Alarm").
Default setting The B-TEL99 default PIN is 22.
PROGRAMMING 23
To Next Page
Loading...