Bentel B-TEL99 - Activation mode

Option 7) Dial-tone type
It is possible to select [1]: Italian territory dial tone; [2]: Italian territory dial
tone and continuous tone.
+
This option is active when 2 (dial-tone check enabled) is selected for op-
tion 5.
Default setting The default setting is [2]: both tones recognised.
Select the dial-tone type as follows.
Access the programming phase ...
1
Press a. a
è
2
Press b. b
è
3
Press 7 (option number). 7
è
4
Select the dial-tone type:
1 = Italian dial tone only;
2 = Italian and continuous tone.
1 or 2
or
5
Press e to confirm and quit. e
è
Activation mode
By means of the jumper 16 it is possible to program B-TEL99 activation by
positive drop or negative command.
Default setting The default setting is activation by positive drop.
To set the activation mode proceed as follows:
Ø remove the four screws 5 and the cover of the B-TEL99;
Ø position the jumper 16 between pins 1 and 2 for activation by positive
drop;
Ø position the jumper 16 between pins 2 and 3 for activation by negative
command.
PROGRAMMING 29